3d stuff

Andrew Price's video on Blender Compositing

https://www.youtube.com/watch?v=fWcCkQ3943Y

------------------------------

http://www.cgmasters.net/free-tutorials/5-little-known-tricks-in-blenders-outliner/

https://renderedsmoothie.wordpress.com/2013/07/02/cycles-skies/

---------------------------

https://creativemarket.com/
http://3d.about.com/od/Career-Resources/tp/Top-Ten-Places-To-Sell-3D-Models-Online.htm

Just use a clay material for your car. Settings: The default material, spec hardness to 8.
And for lighting: Delete all lights and only use Ambient Occlusion with settings: Factor: 1.000 Blend Mode: Add
That's how I make clay renders.


http://www.shapeways.com/tutorials/prepping_blender_files_for_3d_printing

http://3dprintingninja.blogspot.com/2014/12/non-manifolds-automatic-fixing-methods.html

http://autoautomobiles.narod.ru/english/volkswagen/Volkswagen-Beetle-1200-1964/

I don't think you can switch drawing units after you've set them for the file

If you are working in inches (have your dim's set to inches), draw a line at 10. This will be 10 "drawing units" and the drawing units are set to inches.

Then draw another one or copy & paste (or offset) the first line. Then scale it.

25.4 mm = 1 inch. So you need to scale it down by 1/25.4

However, you can't enter a fraction with a non-whole number denominator. Thus you need to express that ratio with a whole number denominator.

Anyone?

Anyone?

Anyone?

Bueller?

The scale factor will be 5/127.

Then if you dimension it (with alternate units enabled), it will show 0.394 inches [10 mm]. Of if you're using fractional or engineering units it will show 3/8 [10].

If you start in mm and draw your first line, then you copy it (or offset) and then scale it up with a scale factor of 25.4. Then you'll have a 10 mm line and one which will dimension as 254 mm [10 in].